Press the 'Report' button to get a report that shows a load flow summary and detailed load flow results at each bus.įinally, start simulation and check that it starts in steady state. Note that the Load flow Bus block displays the bus voltage magnitude and phase angle as block annotations. Press the 'Apply' button to apply the load flow solution to the model in order to start the simulation in steady-state. Home Simulink How to set the sampling frequency of discrete powergui in Simulink. The Load flow parameters are defined in the Load Flow tab of the Synchronous and Asynchronous machine blocks, Three-Phase Source block, Three-Phase Dynamic Load block, and the Three-Phase RLC Load blocks. To work around this issue, open the library window by right-clicking on SimPowerSystems and choosing 'Open the SimPowerSystems library,' or by typing. The five Load Flow Bus blocks are used to specify the bus base voltages and to specify the voltage at PV bus and the voltage and angle of the swing bus. We have verified that there is a bug in SimPowerSystems 4.0 (R14SP1) that prevents the PowerGUI from being visible in the Simulink Library Browser. A 150 MW power plant using a 13.8 kV synchronous generator is connected at the 120 kV bus through a 13.8 kV/ 120 kV transformer. The 120 kV network is modeled by a simple inductive voltage source (short circuit power of 1200 MVA) using the Three-Phase Source block. The model shows a 9 MW wind farm using asynchronous generators and exporting power to a 120 kV network through a 25-kV distribution feeder. To use Matlab/simulink/simscape/powersystem to model power electronic systems.
0 Comments
Leave a Reply. |